Hello,
I am running into the following issue when attempting to boot my Dreamplug. I am still very new to the Dreamplug and Marvell environment. Any help would be greatly appreciated.
U-Boot 2011.06 (Oct 15 2011 - 02:02:08)
Marvell-DreamPlug
SoC: Kirkwood 88F6281_A0
DRAM: 512 MiB
SF: Detected MX25L1606 with page size 256, total 1 MiB
In: serial
Out: serial
Err: serial
Net: egiga0, egiga1
88E1121 Initialized on egiga0
88E1121 Initialized on egiga1
Hit any key to stop autoboot: 0
No link on egiga0
No link on egiga1
ping failed; host 192.168.2.1 is not alive
No link on egiga1
No link on egiga0
ping failed; host 192.168.2.1 is not alive
(Re)start USB...
USB: Register 10011 NbrPorts 1
USB EHCI 1.00
scanning bus for devices... 6 USB Device(s) found
scanning bus for storage devices... Device NOT ready
Request Sense returned 06 28 00
Device NOT ready
Request Sense returned 02 3A 00
2 Storage Device(s) found
** Bad partition 1 **
Wrong Image Format for bootm command
ERROR: can't get kernel image!
Marvell>> usb start
(Re)start USB...
USB: Register 10011 NbrPorts 1
USB EHCI 1.00
scanning bus for devices... 6 USB Device(s) found
scanning bus for storage devices... Device NOT ready
Request Sense returned 06 28 00
Device NOT ready
Request Sense returned 02 3A 00
2 Storage Device(s) found
Marvell>> usb storage
Device 0: Vendor: Generic Rev: 9451 Prod: STORAGE DEVICE
Type: Removable Hard Disk
Capacity: 3781.5 MB = 3.6 GB (7744512 x 512)
Device 1: Vendor: Generic Rev: 9451 Prod: STORAGE DEVICE
Type: Removable Hard Disk
Capacity: not available
Marvell>> fatls usb 0 /
Device NOT ready
Request Sense returned 02 3A 00
** Can't read from device 0 **
** Unable to use usb 0:1 for fatls **
Marvell>>
Thanks
